INCRA M5000RPANEL Replacement Right Sled Panel for the Miter 5000 INCRA M5000RPANEL Replacement Right Sled Panel for the Miter 5000
Features-
Miter 5000 Sled Replacement Panel
• The Miter 5000 Sled is customized exactly for your own saw by installing the entire sled and then making a single cut through the right panel to give you a "zero clearance" sled edge for excellent workpiece support. This newly separated sled panel is then locked in place using the included miter channel locking devices (Incra Miter Sliders). Easily removed and reattached this panel is permanently used unless you change saws. Obviously any "zero clearance" cut will be in the wrong place should you change table saws and having a replacement panel available keeps maintains the remarkable value of your
Miter 5000.
• To replace your panel, you simply remove the secondary panel at the T-Slot extrusion and then attach your replacement panel. Once again you make a "zero clearance" cut of the new panel and attach the resulting piece as before. Below you can see the same exact setup with a left tilt Shopsmith saw.
'); } else { document.write('Close window'); } window.focus(); //-->