INCRA MITER5000 Miter Gauge with Telescoping 64 INCRA MITER5000 Miter Gauge with Telescoping 64" Flip Shop Stop
Features-
The Miter 5000 blends the incremental angle control features of the Miter 3000SE with a very special 3-panel Sled for the ultimate miter cutting workstation for the table saw.

• A Renewable Right Panel provides zero-clearance tear-out control and cut-off support on both sides of the blade. Two aluminum T-tracks are embedded in the MDF panel top to secure an included work piece hold-down clamp and to provide absolute rigid support for the 36" to 64" telescoping IncraLOCK Cut-off Fence. Will crosscut a 25" wide board with full control on a standard 10" table saw. The Miter5000 by INCRA delivers perfect, repeatable accuracy. First time, Every time, Any angle.
• Hold Down Clamp is included with every Miter 5000 is this simple and incredibly useful Hold Down Clamp which locks your workpiece onto the sled for maximum accuracy and the cleanest cuts possible. It only takes seconds to use and provides the rigidity needed for world class results.
• Miter 5000 Sled Replacement Panel In Use
The Miter 5000 Sled is customized exactly for your own saw by installing the entire sled and then making a single cut through the right panel to give you a "zero clearance" sled edge for excellent workpiece support. This newly separated sled panel is then locked in place using the included miter channel locking devices (Incra Miter Sliders). Easily removed and reattached this panel is permanently used unless you change saws. Obviously any "zero clearance" cut will be in the wrong place should you change table saws and having a replacement panel available keeps maintains the remarkable value of your Miter 5000.
To replace your panel, you simply remove the secondary panel at the T-Slot extrusion and then attach your replacement panel. Once again you make a "zero clearance" cut of the new panel and attach the resulting piece as before.

GlideLOCK Miter Bar -
• Six expansion disks adjust both sides of the bar for ZERO side play, anti-friction travel on all table saws with standard 3/4" x 3/8" or near-standard miter gauge channels, including Delta, Craftsman, imports, etc. This means that all of INCRA's incredible precision will actually show up in your work because the bar CAN'T wiggle around in the miter slot

Special Edition Telescoping INCRA-LOCK Fence-
• This Special Edition Miter Fence telescopes from 18' to a full 31' length. Includes the Dual Flip Shop Stop and INCRA's patented Automatic Positioning Control.

AngleLOCK Indexing-
•Precision angle indexing teeth are laser cut in solid steel to lock in 364 positive angle stops in 1/2 degree, 1 degree or 5 degrees increments over a full 180 degree range. it's also continuously adjustable between 1/2 degree steps.

Specifications-
•Precision Angle Stops: 364
• Angle Between Stops: 1/2 degrees
• Vernier Cursor: N/A
• Special Stops: + -22-1/2 degrees & + -67-1/2 degrees
• Angle Range: 180 degrees
• Miter Bar Length: 25.375"
• Miter Bar Adjustments: 10
• Fence Type: Flip Fence
• Fence Length: 36"
• Telescoping Range: 36" to 64"
• Stop Positioner: Flip Shop Stop
• Angular Accuracy: 1/50 degrees
• Angular Repeatability: 1/100 degrees
'); } else { document.write('Close window'); } window.focus(); //-->