Powermatic 1791284 TS29 Shaper, 7-1/2HP 3PH 230/460V with Sliding Table Powermatic 1791284 TS29 Shaper, 7-1/2HP 3PH 230/460V with Sliding Table
Features-
• Sliding table with 4-foot stroke works with miter head, hold-down and fence to accomodate everything from multiple end cuts to tenons
• Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability
• Large table with built-in slider with room for stock feeder
• 7" vertical spindle travel allows stacked tooling
• Spindle tilts negative 5° to positive 45° for increased versatility
• Large diameter multiple table inserts accomodate virtually any size cutter
• Five spindle speeds in forward and reverse with lighted indicator

Specifications:
UPC Code: 662755464232
Height: 53 Inches
Width: 44 Inches
Length: 51 Inches
Weight: 1100 Pounds
Shipping Weight: 1280 Pounds
Spindle Speed: 3000, 4000, 6000, 8000 and 10,000 RPM
Reversable: Yes
Spindle Diameter: 3/4, 1 and 1 1/4"
Spindle Size Under Nut: 3/4 (3 1/2), 1 (6 1/4) and 1 1/4 (6 1/4)"
Spindle Travel: 7
Tilting Spindle: 45° forward, 5° back
Table Size: 51 1/2 x 33 1/2"
Table Height From Floor:
Table T-Slot:
Table Opening Diameter:
Table Insert Opening Diameter:
Fence Size (L x H): 46 x 5"
Fence Travel (Major and Minor): 5 3/8 and 3 5/8"
Slide Table Size (L x W): 11 1/4 x 51 1/4"
Table Travel: 49 1/4"
Table Inserts: one tilting, two straight
Maximum Diameter Cutter Below Table: 9"
Maximum Diameter Cutter Above Table: 12"
Router Bit Collet Diameter: 1/4 and 1/2"
Dust Port Outside Diameter: 5" (dual ports)
Dust Collection Minimum CFM Required: 800 cu.ft/min
Electrical Controls - Magnetic Starter: Yes
Digital Readouts:
Motor Power: 7½ HP
Motor Voltage: 230 / 460 V
Prewired Voltage: 230 V
Motor Current:
Motor Phase: 3 Ph
'); } else { document.write('Close window'); } window.focus(); //-->