|Shop Fox M1112 Gunsmith Lathe with Stand|
This superb gearhead lathe is in the bull's eye with its high-tolerance bearings, D1-5 camlock spindle, outboard spindle bore supports, quick change gearbox, induction-hardened bed ways, and its extra fine longitudinal feed rate of 0.0011"/r and cross feed rate of 0.0004"/r. Other features include a heavy-duty vibration dampening cast iron stand, ball bearing tipped follow rest and steady rest, and a tailstock that can be tightened with a torque wrench to maintain precision chuck-to-tailstock alignment every time the tailstock is locked down. Even if you are not a gunsmith, you'll appreciate all the precision and features this lathe offers.
Removable gap bed allows turnings up to 17" in diameter
Nine spindle speeds ranging from 70 to 1,400 RPM
Easy to use lever controls
Hardened and ground cast iron bed
Cuts 4-112 Standard TPI and .2-4.5 Metric
Full length splash guard
On/off reverse switch on carriage
Halogen work light
Ball bearing steady/follow rests
Outboard end support screws
Socket for tailstock lock
Cast iron stand with extended base
Cast aluminum gear cover
D1-5 spindle nose (6 pin)
1-5/8" spindle bore
6" 3-Jaw chuck with two sets of jaws
8" 4-Jaw chuck with reversible jaws
10" face plate
Quick change tool post with one tool holder
2 MT#3 dead centers (1 carbide tipped)
1 MT#3 live center
Set of six change gears
1/2" chuck w/ MT#3 arbor
Motor: 2 HP, 220V, single-phase, 9 Amps, 60 Hz, 1,725 RPM
Swing over bed: 12"
Swing over gap: 17"
Swing over cross slide: 7"
Distance between centers: 36"
Bed width: 7-1/4"
Spindle bore: 1-5/8"
Spindle nose taper: MT#5
Spindle nose: D1-5 Camlock
Cross slide travel: 6-1/4"
Compound travel: 3-1/4"
Tailstock barrel taper: MT#3
Tailstock barrel travel: 4"
Number of speeds: 9
Range of speeds 70, 200, 220, 270, 360, 600, 800, 1000, 1400 RPM
Height w/o stand: 23"
Height w/ stand: 54-1/2"
Length w/ stand: 61"
Width of stand: 26"
Approximate shipping weight: 1,364 lbs.