Shop Fox W1738 37 Shop Fox W1738 37" Wide Three-Phase Belt Sander
Built for industrial shop use, the 37" wide-belt sander is available as the Model W1738, 15 HP, 220V/440V, three-phase unit. This unit uses triple V-belt driven double sanding drums with a 1 HP variable-speed conveyor, and can sand doors and panels up to 36 1?2" wide. For light-feather sanding, the key pad and digital readout, and the microadjustable felt/graphite platen provide excellent sanding to tolerances within 0.005". For aggressive sanding, the amp draw meter enables the operator to prevent motor overload, and the air-operated oscillation system allow for superb gouge-free finished panels.

•Built in air filter/regulator
•Independent motor control
•Pneumatic belt tracking and tensioning
•Amp meter for load measurement
•Safety shut-off bar
•Digital readout and control panel
•(3) 4" dust ports
•Steel cabinet
•Rubber infeed drum
•Steel outfeed drum
•Rubber pressure drums
•Micro-adjustable graphite/felt platen
•Sanding motor: 15 HP, 220/440V, 3-phase, 36/18 Amp, 1725 RPM, 60 Hz cycle, triple V-belt drive
•Conveyor motor: 1 HP, 220/440V, 3-phase, 3.4/1.7 Amp, 60 Hz cycle, variable speed belt/gearbox
•Table elevation motor: 1/4 HP, 220/440V, 3-phase, 1.2/0.6 Amp, 1725 RPM, 60 Hz cycle, V-belt power transfer
•Maximum board width: 36-1/2"
•Maximum board thickness: 6"
•Minimum board length: 14"
•Air requirements: 70 PSI
•Surface speed of drums: 2,565 FPM
•Conveyor feed rate: Variable, 15-49 FPM
•Overall dimensions: 69-5/8"H x 52-1/8"W x 49-3/8"D
•Approximate shipping weight: 2310 lbs.
'); } else { document.write('Close window'); } window.focus(); //-->